steam engine

Post by **Swiss V8** » Mon Jul 11, 2016 1:12 pm

That's how nice holidays can end...

Post by **SRF** » Mon Jul 11, 2016 6:17 pm

Now you can throw it away and install a really expensive stroker motor

Post by **CanuckHoss** » Mon Jul 11, 2016 7:36 pm

What happened??

Post by **Carl La Fong** » Mon Jul 11, 2016 8:37 pm

looks like a blown head gasket at the front cylinder.
Is it just the picture or is there an inordinate amount of sludge in that engine???

Post by **randy burkey** » Mon Jul 11, 2016 8:37 pm

I would guess that since the front piston is lighter in color, And the thread is on steam engines. I would guess a head gasket or worse was letting water into cylinder?

Post by **randy burkey** » Mon Jul 11, 2016 8:39 pm

I thought it looked like a lot of sludge also....What oil do you use??

Post by **GordonBH** » Tue Jul 12, 2016 11:48 am

Yes it's a blown head gasket, right hand side only but both heads to be sorted I believe, hopefully that piston and wall's OK. I also thought that oil looked sludgy...

Time to have a thorough purge Martin and put in 5W40 to cope with the Swiss temps.

Post by **Swiss V8** » Wed Jul 13, 2016 3:51 pm

By taking the heads off, because of steaming exhaust, we discovered that three bolts were not thight at the lower front of the right side. Therefore water nearly managed to clean the first cylinder.
Now we wait for the redone heads and the new gasket. In 10 days all is ready to ride again...

Post by **GordonBH** » Thu Jul 14, 2016 4:07 pm

Good news and a lesson in checking our bolts every year.

Welcome to the Worldwide V8 Bikers Forum

steam engine

steam engine

Re: steam engine

Re: steam engine

Re: steam engine

Re: steam engine

Re: steam engine

Re: steam engine

Re: steam engine

Re: steam engine