Welcome to the Worldwide V8 Bikers Forum

Is it best to adjust the belt on stands or with the bike on the ground? The manual does not say. I have done them on he ground before but am having a problem. It is the same distance on both sides and the tension is set to 400. When I walk the bike back, the belt walks into the tire in about 8 ft but goes back to center 8 ft forward. What am I missing?. it has been years since I did one. It does have the open rear pulley. Also made sure that the belt was in the middle of the pulley when it was loose before starting the adjustment process.

Bill,
usually I lift the back a bit (just put a little scisscor type jack underneath the tranny) and let the engine run. Thats the easiest way to see if the belt will stay centered. Go to 450 (I would think with the 606) with the left screw and center with the right and check again.
Once you are at it you can also check the trans fluid level by putting it in gear and let it run for a couple of minutes.
Good luck
Peter

Bill -

I always adjusted my belt with rear up on stands. Like Peter I had engine running and would watch the belt track. I didn't have an open pully on my bike but less then 500# tension my "little engine" would slip the belt. I can't imagine the open pully would allow you to run less tension

Don