Welcome to the Worldwide V8 Bikers Forum

Posted: **Thu Sep 24, 2020 7:01 am**

What is the torque for the front axle on the inverted front forks . Too lazy to look it up and don't remember .

Thanks Jack
HOGV8

Posted: **Fri Sep 25, 2020 10:18 am**

I think it's 50 ' lbs but can't seem to find it .

Posted: **Fri Sep 25, 2020 6:24 pm**

Posted: **Sat Sep 26, 2020 6:31 am**

Thanks Puff

Posted: **Sun Sep 27, 2020 8:28 am**

What size axle? 3/4 or 1 ".

Posted: **Mon Sep 28, 2020 6:08 am**

3/4" Gerry, I've removed and replaced my axle several times and thought it was 50 lbs but just thought I'd check to be sure .

Posted: **Tue Sep 29, 2020 7:42 am**

Just an FYI, you and Puff were correct at 50 lbs for the 3/4" axle. The 1" axle is 55 lbs per the factory.

Posted: **Fri Oct 02, 2020 6:14 am**

Just keep going until you strip a thread then back it off 1/4 turn. Been good for me for 50 years

Posted: **Fri Oct 02, 2020 10:37 am**

knockdolian wrote:Just keep going until you strip a thread then back it off 1/4 turn. Been good for me for 50 years

Been wrenching all my life and I just don't work that way especially where there's an axle and bearings involved .

Posted: **Sat Oct 03, 2020 1:12 am**

Yes, it was a bit of light humour.

Posted: **Sat Oct 03, 2020 11:41 pm**

I see this was a few weeks ago, but for the sake of others who might need this, don't forget to set the pinch bolt, afterward.

Axle